Gantry Side Plates.=>
Let's Get Started!
- These build notes are for the 3DTek.xyz version of the open source XCarve, known as the XYZ-Carve.
- We have made many modifications to the original Inventables design and so some of these notes are not applicable to machines not obtained through 3DTek.xyz
-
Each step of the instructions shows a
- bill Of Materials (BOM)
- few notes about potential 'gotchas' these are marked with this pin icon , and these notes should be read before going any further on that page.
- CAD model with assembly animation
- Models, Animations, Drawings, and Images are all best viewed in full screen using the button at the right of the bottom toolbar.
- The design and Animate button in the upper right corner of the CAD model allow switching between design view and Assembly Animation view.
- The toolbar at the bottom of the CAD model is useful in interrogating the model
- And the home button to reset
Try them out in the Full XYZ Carve model below, this is a large model so be patient while it loads
Gantry Side Plates.=>